Sorry your browser is not supported!

You are using an outdated browser that does not support modern web technologies, in order to use this site please update to a new browser.

Browsers supported include Chrome, FireFox, Safari, Opera, Internet Explorer 10+ or Microsoft Edge.

Newcomers DBPro Corner / Using Sparky's dll to find the Parallel Angle of a polygon?

Author
Message
RUCCUS
19
Years of Service
User Offline
Joined: 11th Dec 2004
Location: Canada
Posted: 27th Dec 2006 05:42
Link
Its been a while since Ive used Sparky's dll, I know I should know this since I made an entire thread on the topic, but I cant seem to figure it out .

Basically, I want to find the xyz angle that will point an object so that it ends up being parallel to the polygon hit. I know how to point my object so that it faces the same direction as the polygon hit, and then I could just pitch the object down 90 degrees, but I was wondering if there was a different way to get the data Im looking for using sparky's command set.

Any ideas?

Thanks,
- RUC'

Back to top
Profile PM Email Website
TEH_CODERER
21
Years of Service
User Offline
Joined: 12th Nov 2003
Location: Right behind you!
Posted: 27th Dec 2006 10:17
Link
I'm not certain but I was doing the same thing for making Manuel wall run and the only way I could find was to rotate the object and extra 90 degrees.

Back to top
Profile PM Email
Back to top

Login to post a reply

Server time is: 2024-11-26 05:33:12
Your offset time is: 2024-11-26 05:33:12